65lb.ft. is what the specs are but I ran mine to 80 just in case.
I may have to back off on that once I finally get the car dropped to the ground and see how they are. I hope there's no binding taking place with the extra torque.
And I used an lithium axle grease on mine and like you, applied liberally to the bushing inside and out.
Misnblu.com
Newbie member since 1999
Thank you Dave and JBO!
So i just checked on theses cause i wanted a set but LZM no longer makes them. anybody know where i could get a set?
There is a post about these bushings about 10 threads down from where this thread now is
I'll sell you a set of LMZ rear bushings if you want.
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO