Someone is selling 18 inch rims that were on a Mazda 6 (the guy doesn't know anything about sizes) so i searched the bolt pattern and it said 5X114.3, my question is will they fit on my 2001 Sunfire with adapters or will they stick out too much?
www.funnybikeshow.com
What is wrong wih buying set of wheels in the correct bolt pattern?
The 4 wheels and tires are only $200 and i am looking for that design !!!
I'm also broke and may attempt suicide .
www.funnybikeshow.com
What's the offset? Width?
Legit adapters will run you around $200...
________________________________________.
Still not low enough for a signature.
Twenty4z wrote:What's the offset? Width?
Legit adapters will run you around $200...
and likely longer studs and time to swap them out. in the end I would rather just buy different set of rims. buy them, keep the tires and sell the rims. cut your cost down. unless the tires are worthless.
this is the start of my signature: have you read the
RULES yet?
my carDomain updated 6/11/10 Forged and Supercharged
the guy has no idea either !
www.funnybikeshow.com
s1lver_N1p (forum_Naz1) wrote:Twenty4z wrote:What's the offset? Width?
Legit adapters will run you around $200...
and likely longer studs and time to swap them out. in the end I would rather just buy different set of rims. buy them, keep the tires and sell the rims. cut your cost down. unless the tires are worthless.
I agree with this... buy 'em, clean them up, take the tires, and sell for a decent profit.
I wouldn't be surprised if you could get 400-500 for them... unless they're pretty curbed up.
________________________________________.
Still not low enough for a signature.
Thanks for the replies !
www.funnybikeshow.com
just get a drill bit and reem out the holes a little until they fit......
04 Cav. 2dr. 5spd. My DD. 'Nuff said.
Have a feeling he was being sarcastic.
RED wrote:Have a feeling he was being sarcastic.
04 Cav. 2dr. 5spd. My DD. 'Nuff said.
