ZZP 3.1 Pulley Install - Photos & Media Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
ZZP 3.1 Pulley Install
Monday, January 12, 2015 10:09 PM
Here are some various pics from the Install. All that was done is the 3.1 pulley.
Attachments
20150108_211545.jpg (32k)
20150108_212155.jpg (35k)
20150108_212152.jpg (34k)
20150108_210604.jpg (44k)
20150108_211318.jpg (31k)


Re: ZZP 3.1 Pulley Install
Monday, January 12, 2015 10:15 PM
I am having some issues with WOT near 13 pounds of PSI. The car has about 138,000 miles. I installed the charger around 70 I believe. I changed the plugs then and that was the only time. I have ordered the NGK 3787's and will be installing them tommoro. I hope this solves the issue. I have some other ideas if not but let's not go there yet. lol
Re: ZZP 3.1 Pulley Install
Tuesday, January 13, 2015 1:09 AM
What are the issues?




Re: ZZP 3.1 Pulley Install
Tuesday, January 13, 2015 8:30 AM
13 psi is borderline needing 2 steps cooler than stock plug..

Assuming that you are stock compression ratio..... could you post a picture of the firing electrode and insulator?



Re: ZZP 3.1 Pulley Install
Tuesday, January 13, 2015 10:03 AM
jason norwood wrote:13 psi is borderline needing 2 steps cooler than stock plug..

Assuming that you are stock compression ratio..... could you post a picture of the firing electrode and insulator?


this was where i was at before i sold the EVOFIRE. meth and colder plugs were in the future, but i was polished ported, and 3.0 pulley. would hit 16 PSI on a good day.



Re: ZZP 3.1 Pulley Install
Tuesday, January 13, 2015 4:19 PM
Check the other link and you can see my old plug
Re: ZZP 3.1 Pulley Install
Tuesday, January 13, 2015 5:30 PM
Just an update
Attachments
20150113_202212.jpg (57k)
20150113_202205.jpg (44k)
20150113_202158.jpg (62k)

Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search