david depuy

jfk


Location: missouri
Joined: Friday, August 29, 2003
Last Update: Wednesday, June 1, 2005

Email: ddepuy@earthlink.net

1996 Chevrolet Cavalier

About This Vehicle:

It's still under construction. Currently adding a phantom grip LSD, custom intake manifold to house a twin barrel 5.0 mustang throttle body and 5.0 injectors. Made a custom fuel rail to accomidate this set-up.

Body Style: Coupe
Color: teal and primer
Engine: 2.2L I4 OHV
Transmission: Manual
Interior: two tone blue
Purchase Date: nov 95
Purchased From: aafes in japan
Build Date: jan 96


MODIFICATIONS

Engine:
  • Still working on it. Painted yellow. All the engine brackets are blue to soon match the car. Roller tip rockers 1.6
  • roller cam
  • bored .040 over w/ 8.1:1 forged piston heads
  • heavy duty connecting rods
  • stainless steel valves
  • heavy duty springs
  • (head and block are getting milled so the compression will raise a little)
  • custom top feed conversion fuel rail setup
  • ARP head studs
  • felpro head gasket
  • self-done port and polish and three angle valve job
Suspension/Wheels/Brakes:
  • RK Sport lowered springs
  • lower a-arm bushings
  • sub-frame brace
  • camber kit
  • 17" rims w/ 205/40/17 HKII
Interior:
  • Fully painted interior (Two tones of blue)
  • dyed carpet (blue)
  • custom short shifter (with the rod below the pivot ball actually extended 1/2" to shorten the throw)
  • electronically actuated passenger air-bag cover(opens to reveal "faze" guages)
  • dvd player mounted into the dash on pass side
  • more bells and whistles in the works!
Exterior:
  • As of now: shaved handles
  • shaved emblems
  • shaved stock tail lights
  • shaved back-up lights
  • shaved antenae
  • shaved key holes
  • custom hood scoop
  • Bomex front with custom grill
  • Blitz rear and sides(molded). L.E.D. tail lights mounted in back bumper along with back-up lights
Audio:
  • older Kenwood head unit
  • 1 farad Blue Lightning cap
  • 1 guage power wire
  • 109 amp alternator
  • 1800 watt memphis amp (D1000)
  • two memphis 15's (not installed yet. designing a box to replace the back seat and to hold my nitrous bottle to be in reach)
  • 400 watt legacy to run mids and highs (all kenwood)
Miscellaneous:
  • 255 liter in-tank fuel pump
  • Spec III clutch
  • MSD programmable DIS-2
  • interface modules
  • coil paks
  • 2 bar map sensor
  • Faze guages: fuel pressure
  • tach
  • oil pressure
  • oil temp
  • boost
  • air/fuel
  • volt
  • egt
Future:
  • turbo and nitrous installed before the motor is started
  • race seats and harnesses
  • custom built roll cage
  • 7.5 inch screen to replace rearview mirror. HPTUNERS REPROGRAMMING SOFTWARE!!!