problems putting car in Drive - Maintenance and Repair Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
problems putting car in Drive
Wednesday, March 17, 2010 5:47 PM
Ok so I'm having issues when I put my car in drive. It hasnt been driven or started since November because of the winter and now that Ive taken it out once again theres been so many problems. Anyways when I start my car and put it into D it makes a Thump noise and it feels like my rear axle bounces. It only happens in D and there is a lot of movement in the engine when its shifted from P-D or N-D. Could it possibly be a bad engine mount? it never happened before the winter and the only mods i did during the winter were a throttlebody spacer and a B&M shift kit. Any help is appreciated. Thanks




Re: problems putting car in Drive
Thursday, March 18, 2010 6:29 AM
bump, anyone?



Re: problems putting car in Drive
Thursday, March 18, 2010 6:33 AM
i had a similar issue.. mine was actually the transmission mount. i replaced it with the ttr and havnt looked back since...



Re: problems putting car in Drive
Saturday, March 27, 2010 5:07 PM
Get the TTR Mount as arrival_04_eco (green98cav) states


-Aaron
www.TurboTechRacing.com

Performance Parts For Cavalier, Sunfire, Cobalts and More!!!
Re: problems putting car in Drive
Sunday, March 28, 2010 5:46 AM
Either trans or engine mount is shot


- 2004 Cavalier - 124k, owned since new



Re: problems putting car in Drive
Thursday, April 01, 2010 2:30 PM
is the B&M kit switch on?....
because if it is that causes your car to jump when you place to gear
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search