Did all the research on here hopefull will be doing this swap in a month or so.Was debating between the 2.5,I have 98 cav 2200 5 speed.As I have read tranny will work,Ill need a cluth engine wiring ecu,Mounts and Fabracate a bracket or fewand a cluster?My question is about suspension and axles.Do you need to do anything with them?And do you need the Converter off the other car for exhaust thanks!Any tips would be helpful too!Would I be better off with a 2.4 swap or should i go ith this!

good luck with the swap Peter. let me know if you need a hand with anything





M62 KIT for sale PM ME

I heard the 3.4 down pipe would bolt into the j.. but it didnt on mine... for my cluster I just left the stock j computer alone and just wired up the sensors for my cluster.. I actaully have the v6 speed sensor hooked to both computers without any problems.. I heard you cant do that with the temp guage though.. something to do with ohms with be cut in half, most people run two temp sensors, one for the v6 pcm and one for the gauges.. good luck with the swap, mine was hard at all.. Hell i even wired it without a wiring diagram.. but then again i lost my torque converter lockup somewhere along the line..


- Your not-so-local, untrained, uncertified, backyard mechanic. But my @!#$ runs