So, It looks like I am needing to change out my plastic lines coming off the fuel pump because both the return and feed are kinked like 3 inches at the end(by the filter). Now I know they can not be changed up by the pump, but I was wondering how would I connect a hard line to that plastic line? The connector I have listed below I am going to use to connect to my booster pump.
http://www.jegs.com/i/Aeromotive/027/15118/10002/-1
I got that part figured out, but how do I connect the plastic line to a new fuel hard line? Any suggestions?
Thanks.
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD
AUTOMATIC!!
328 HP
306 TQ
If it were me I would use a multi-barbed hose fitting to 3/8 tube flare adapter. Then press the barbed end into the plastic line right at the sending unit. Then, run metal line down to your fuel filter.
Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!
You can get ends similar to the quick connect style you're using that are made to slip on to the end of a plastic line. They are found in repair kits. You can also buy hard lines with the proper tube bead to accept the quick connect.
The repair fitting is similar to
this.
The hard line is usually called a filter repair kit.
Here is some more info that might help.
Ahhh thank you Roofy and Chris. Lots of help..
~2014 New Z under the knife, same heart different body~
______________________
WHITECAVY no more
2012 numbers - 4SPD AUTOMATIC!!
328 HP
306 TQ
