Well, Ladies and Gents, I've finally got the ball rolling for my phoenix project and I put on some new rims on my cav and one of the studs snapped off with the bolt nut and I have to buy a new stud for the rear. My question is, how hard or complicated is it to take the drums off to install the new wheel studs? I've done it for the fronts and it was a piece of cake.... But the rears, i've never messed with them... Any help please?
STUFF FOR SALE... Please click
here and see more info...
remove all the brake stuff and use a T55 torx bit to take off the hub
My car may run 18s, but I can do your taxes in 10 seconds flat.
JBO lube - they would never have enough in stock and we'd never see RodimusPrime again
you dont have to remove any of the brake stuff
just the tire and drum
that's awesome... thanks Alias1429...
I got three new studs on hand and will be installing a new one and have two on the side in case something like this happens again.
STUFF FOR SALE... Please click
here and see more info...
i told you the rears are easy to do
lol
get busy
LOL @ Eric... I already did em. Easy as pie...
Thank you all for your help.
STUFF FOR SALE... Please click
here and see more info...
I had a stud come loose inside of the rotor on my Camaro, so I drilled it out and I just ended up replacing all of the studs on that part of the car just to have a peace of mind.
1983 Camaro Z28
I thought of doing that myself... but not now.
STUFF FOR SALE... Please click
here and see more info...
