I was on the way out to primer my car today. I took a right turn and my cylinder snapped in half right above the threads where it threads into the bracket. I was wondering if anyone knew what this could be from or has heard of this hapening to anyone else?

I am guessing you are talking about the cylinder being on the front. I have heard of this happening many of times and so have others. Its cause the stress on the cylinder and they aren't made to be turning. I am not quite experienced with them but I am sure someone here will explain it alot better. But cylinders aren't the best for the front.

snapped in the rear?or the front?i have eai blue parker cylinders in the rear and the x-airs in the front.its almost been 2 years and i havent had any problems.if you have the regular cylinders on the front they will break as said above.go to http://www.streetsourcemag.com/ go on the forum page and look up eai cylinders.alot of ppl have had problems with the eai cylinders.hope any of this helps good luck.