99 Airbag schematic? - Audio & Electronics Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
99 Airbag schematic?
Friday, March 10, 2006 8:47 PM
Anyone have a 99 service manual? Actually, anything 96-99 should be the same. I'm trying to determine if the 99 passenger bag will work on my 2000, because the plug is the same, but the wires appear to be switched A to B. (Green/White and White/Black, they switch in the plug).

I could just switch the plugs... makes little difference to me. But I want to make sure I have the high and low signals straight

In fact, I don't even need the diagram. Just tell me if the Green/White is A, or B.






Re: 99 Airbag schematic?
Friday, October 22, 2010 2:12 PM
Lenko...
What did you find out about this?
I've notice there is no safe way to dismantle the connector. The only way I'm seeing is to snip the wires and reconnect?
Now putting a 96-99 airbag in a 2000-2002 car, could there be a problem other then the connectors... deployment?
I know the 98-99 & 00-02 are depowered airbags.

I know you have experience on this... so spill it!



>>>For Sale? Clicky!<<<
-----The orginal Mr.Goodwrench on the JBO since 11/99-----

Re: 99 Airbag schematic?
Friday, October 22, 2010 9:35 PM
I just hooked it up... no warning lights, so I was assuming it was working correctly.

I shoved a needle in the end of the connector to release the tab that holds the pin in place... slides out no problem. In fact, I was using a 99 driver's side bag as well... with a 2000 SDM. No problems.

Never set them off though



Re: 99 Airbag schematic?
Saturday, October 23, 2010 7:17 AM
This is good to know, and good news.
I should have been more specific on my part. The connector that I was thinking and I didn't mention was the one on the clockspring that connects to the "car" under the dash. That's the one that looks to be a PIA to pull out safely as there is spring loaded "ground springs."
Like on this vid at 0:37:


Now would it be a good idea to cut off the old connector and connect the new connector so it can plug to the car/SDM? From what I saw, it was only a green & white wire. Do you have experience on that part?



>>>For Sale? Clicky!<<<
-----The orginal Mr.Goodwrench on the JBO since 11/99-----

Re: 99 Airbag schematic?
Wednesday, October 27, 2010 11:52 PM
I swapped the other side of the same connector... easier.

The wire colours don't seem to make a difference as long as they connect to something. It's not polarized...



Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search