Removal Of Backing, And Doors For Speakers... - Audio & Electronics Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Removal Of Backing, And Doors For Speakers...
Sunday, July 08, 2007 5:47 PM
I was wondering how in the hell to remove the fabric, and board in the back of my 01 Cavalier sedan, to get to the speakers. I removed the 3 plastic clips up near the window, and also the 2 plastic peg screws behind the folding seat... I can't seem to get the damn board loose, or removed without cracking, or breaking anything further then I started to...

Also, how in the hell do I remove the front right door panel to get to that speaker as well? I am assuming I just needed to remove the window handle with a tool, and then it should have just popped off after I removed the screws... But just making sure... I always seem to think the things that pop off don't, and have trouble, or the things that aren't supposed to pop off, and break them... Heh... Bad habit I guess... I always start a project and end up rushing for no reason, cause I start it too late...

The damn sound on the right side of my car sometimes works, and then sometimes doesn't when I am driving, and comes, and goes... And now finally... Gone. I either blew a speaker on that side, or one of them has a loose wire, or something funky... Wanted to put better quality speakers in anyways. Any help would be much appreciated. Thanks.

Re: Removal Of Backing, And Doors For Speakers...
Sunday, July 08, 2007 7:20 PM
it's been a while since I took that part off, but if the rear plastic parts come off, it should come out easier. I didn't have the tool to get the seatbelt bolt off(I have the coupe), so I ended up just trying to pull it out, I thought I was going to break it, and it did bend a little, but it went together and you can't even tell.
if you can remove the plastic parts it should be easier than what I had to do.

as for the door, that sounds right, it there are metal clips in the door, some will likely come off in the metal, just pull the metal parts out and put them back on the panel(I know some of the other trim parts do this, I just replaced the headliner with a charcoal colored one, now its all that color(looks so nice now)).


Re: Removal Of Backing, And Doors For Speakers...
Sunday, July 08, 2007 10:17 PM
Screws along the bottom edge of the door panel, and a pair in the pull handle too.



Re: Removal Of Backing, And Doors For Speakers...
Tuesday, July 10, 2007 7:29 PM
right, something you just do and don't think about I guess


Re: Removal Of Backing, And Doors For Speakers...
Sunday, July 15, 2007 7:08 PM
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search