Spooling - Boost Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Spooling
Monday, February 04, 2008 1:29 PM
I was just wondering where peoples' turbos kick in, it seems like everyone runs about 4+ft of piping.


_________________________



Re: Spooling
Monday, February 04, 2008 1:33 PM
Full pressure(7psi) at 1800 rpm in 5th gear using cruise to accelerate......



Re: Spooling
Monday, February 04, 2008 1:36 PM
^ About the same.



Re: Spooling
Monday, February 04, 2008 2:00 PM
12lbs at 3500rpm (t3/t4) from vacuum at about 30km/hr in 2nd



Re: Spooling
Monday, February 04, 2008 4:59 PM
5lbs at 3000rpm in second with a 50 trim t3


Veritas Aequitas


Re: Spooling
Monday, February 04, 2008 6:00 PM
Ok, thanks.


_________________________


Re: Spooling
Monday, February 04, 2008 7:06 PM
Here you go.....

RPMS are on the bottom......Pressure is on the left. Highlighted cells tell exactly what rpm vs boost the car saw during a particular pull.

220 kpa = 17.2 psi (Chart shows up to 95% of range of the car......which was 18 psi on a TO4E turbo)








Signature Powered by Exploited Racing
Re: Spooling
Monday, February 04, 2008 9:40 PM
holy crap da mack is back






Re: Spooling
Tuesday, February 05, 2008 8:14 AM
Wow, that was a lot more than expected thanks big time Johnny!


_________________________


Re: Spooling
Tuesday, February 05, 2008 8:29 AM
9 psi on a T3/T04B with a .70ar on the compressor, max pressure at 2800 RPMs.



Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search