Yeah guys, I just replaced my transmission on my 97' Z24. and I noticed that the driver side output seal is leaking pretty good. I was wondering how hard is it to replace the output seals on the Isuzu 5 speed? Do I need to drop the transmission again or can I just take out the half shafts and take the seals in and out that way?
Thanks for your time,
Jwright

i dont see why you couldnt do that... when i put my tranny in i toook them out when i had the tranny out but i dont see why you couldnt do it that way....

So how did you replace yours? Do they just pull out or do you need a special tool? Sorry for all the questions, I just don't want to take everything out and not know for sure how to replace the seals.
Thanks for your time, greatly appreciated.

yea halfshafts simply slide off. undo them form the knuckle then pry them till they pass the locking ring, then they should slide right out.



My car may run 18s, but I can do your taxes in 10 seconds flat.
JBO lube - they would never have enough in stock and we'd never see RodimusPrime again