Hey

I had the clutch replaced in my 98 Sunfire SE 2.2L and also the slave and master. It currently has a stock clutch and Lighter flywheel. After a couple hours of the driving the pedal looses pressure and has trouble engaging in the gears. It has been opened several times for leaks, but nothing. After bleeding it, it is good for a couple hours of driving and ends up the same again and there is no air in the system when attempting to bleed it.

I'm completely lost on the problem. Can anybody help me out? Also could having a stock clutch and a lighter flywheel cause this problem?

Need this fixed ASAP, planning to drive to BC in couple weeks.

Thanks.

Neet
neetdta@yahoo.ca



Lookin' to make it better.....

Are you seeing air when you bleed it? Have you checked the pressure plate bolts?

Very slight amount of air, everything has been checked and rechecked. My only concern is they put a stock clutch and they told me there is a light flywheel in there, not stock. Could that cause the problem?


Lookin' to make it better.....