Stand alone transmission controller - Transmission Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
Stand alone transmission controller
Thursday, June 11, 2009 5:16 PM
Caboose73
Anyone ever used one of these Tranny control If its bad can anyone suggest a good replacement that i can use?

http://www.fquick.com/Caboose73

Re: Stand alone transmission controller
Tuesday, June 16, 2009 6:14 AM
Joshua Dearman
Damn, that is expensive as all hell. You can run a MS GPIO with Megashift(releasing out of Beta Q3) and do whatever you want. You can even run paddle shifters with it if you wanted.


"Never argue with an idiot. They'll drag you down to their level, then beat you with experience!" -Anonymous
Re: Stand alone transmission controller
Tuesday, June 16, 2009 12:26 PM
Caboose73
Joshua Dearman wrote:Damn, that is expensive as all hell. You can run a MS GPIO with Megashift(releasing out of Beta Q3) and do whatever you want. You can even run paddle shifters with it if you wanted.


Do you have a link were i can read up on this MS GPIO with megashift

http://www.fquick.com/Caboose73
Re: Stand alone transmission controller
Tuesday, June 16, 2009 3:58 PM
Caboose73
Never mind i googled it thanks for the help

http://www.fquick.com/Caboose73
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search

Copyright © 1999 - 2024 GM Enthusiast Network
GM Enthusiast Network is not affiliated with the General Motors Corporation