got my 3 pod pillar and the easy street gauges are to long to fit all the way in, has nayone had this same situation?? i wanted the pillar to just save time for now but looks like i'll have to fiberglass something custom for them instead.


http://www.flickr.com/photos/sndsgood/ https://www.facebook.com/#!/Square1Photography

try Eazy716 (iirc)

My easystreet gauge fits in my pillar. The air line going to the back is a little snug, but other than that it fits perfectly.

yeah mine sticks out about an inch and looks horrible

ya, iread that, and decided to glass the gauges into the bezel. if your pinching those air lines behind the gauges, wouldnt you get an incorrect readout?? do you have any issues Hor??





RIP Saint ........ JBO

Nope, no issues, it's not pinched, just bent a little. I'm 99% sure there is no restrictions of the air. I'll take a pic or two tonight when i take the pod off to paint it.

Sorry for the double post... decided to take pics now.. =)

yea they do fit but its a little tight. i have my pillar pod sitting in my dinning room, i havent had a chance to put it in yet. right now i have my gauges in my center arm rest. open it up and the gauges are right there but i like the fact of being able to see them at all times so thats why im moving them to the pillar

hor, your fitting on your gauge for the airline is about an inch shorter then mine are.


http://www.flickr.com/photos/sndsgood/ https://www.facebook.com/#!/Square1Photography

It's got a little "penis" looking thing on the end of it that the air line is pushed on to. About a 3/4" worth. Where did you get your gauge from? I got mine from Jason @ A+ and it came with that fitting on. Maybe get a new smaller fitting to go on there?

^^ you got a single needle gauge on there not dual needles gauge. Its a easy fit for sure.

I had my 2 easystreet dual needle gauges fitted on a double pod. It was a really tight fit. So now Im relocating those gauges to my center dash.

I had to make those small holes which is already there, to be bigger to be able to fit those air lines. But I highly doubt you will be able to fit 6x 1/4" air lines from there. But you can run other 2 outside from running the other 4 inside just like I did. Hope you can make it to work!



You may will need some of those 1/4" springs to prevent bending those air lines.


You can see the pod how it sits like that.


Make sure you have enough 1/4" air lines! Hope it helps and good luck!








- Darren

gmtunerz.com -||- phewes.snowpants.org -||- zukiworld.com

i want that rag top sooo bad darren.

Phewes wrote:^^ you got a single needle gauge on there not dual needles gauge. Its a easy fit for sure.!

Good point. He didnt specify which one he had =)

yeah your right on that two. ive got dual needes so duel posts that are longer then yours. i dont know why they made them as long as they did, but ive allready started making a pod for them on the passenger side airbag cover so oh well.


http://www.flickr.com/photos/sndsgood/ https://www.facebook.com/#!/Square1Photography

I just have my gauges hanging i need to glass mine in somewhere??

Anyone got pics of custom glassed guages?

Orange Syn wrote:I just have my gauges hanging i need to glass mine in somewhere??

Anyone got pics of custom glassed guages?

give me a week or two since i now have to do it lol


http://www.flickr.com/photos/sndsgood/ https://www.facebook.com/#!/Square1Photography