hey guys. been reading through the forum for quite some time now, just decided to sign up so i could ask a few questions here and there. im going to be building an engine for my car, i race a 4/10 mile dirt oval in north carolina. decided to go with a 95 block and the 98 pistons to up the compression. with the stock internals hold up to this? also, run a factory head gasket or get a steel one? thinking about doing the ARP head studs while im doing it just for safe measure. will this work on a factory tune, or do i/can i tune that computer? using the wiring harness out of a 93? i think. anything you would change? add? do differently? let me know. also. I havent bought a head yet, anything i should do to the head or a certain year model i should get? was figuring probably a 95 head with a 3 angle valve job, fresh springs, and run it. any feedback helps. thanks.