im looking at getting this
splitter for my bc2 kit
my first question is do you think it will look good on this car or should i just not bother
i was thinking about painting it black to match the car because i have absolutely no carbon fiber on the car at all and it just wouldn't seem to match anything
what are some of your guys oppinions
o and how exactly does this bolt up to the bumper? i can see it uses to splitter bars in the front but is that it? something must hold it up towards the rear
dont paint it, it would look good like that, i say you s hould get it
their easy to attach. anthony jones has one on his bc2 front and i have one on my trd front
^^ ecotecpower does too, on his bc2...maybe pm him.
FOR SALE: (5) '95-'99 Z24 Rims
Its really easy to install. Just line it up where you want it and drill some holes inside the bumper then use some bolts and nuts with lock washers. I'm using two on each side and the adjusters. The adjusters help support the front part of it since it sticks out SO far. They look SICK to
Edited 1 time(s). Last edited Friday, August 25, 2006 12:42 PM
ecotecpower wrote:Its really easy to install. Just line it up where you want it and drill some holes inside the bumper then use some bolts and nuts with lock washers. I'm using two on each side and the adjusters. The adjusters help support the front part of it since it sticks out SO far. They look SICK to
yup the rods you can adjust to have the lip down more or up more. i have mine up and its pretty much as tight as it can go
Damn Tom, I want your hood.....
and you dont need any other CF for it to look good on a black car.
SPD RCR Z -
'02 Z24 420whp
SLO GOAT -
'04 GTO 305whp
W41 BOI -
'78 Buick Opel Isuzu W41 Swap
hey where are you getting ur splitter from? i would like one too but not sure if it'll be too big or too small. i have the drift kit on an 03.
ya like ecopower said i have a bolt on each side and then some self taping screws for more support and then of course the stabilizer bars
k5 ftmfw!!
