i currently have on my cav a 02 lipped front and rear and sunfire sides, the sides look good, but dont sit as low as the front, so i wanna change my sides and rear bumper,

anyone know what the clearances are to the ground on a type J kit? i want it to be low, but i dont want it hanging substanially lower then the front

now im on near maxed rksport pro streets, so im in and around a 2.5" drop, so i guess it would be perfect if somebody with ground controls with them lowered 3/4 of the way down would post, or even teins or prostreets

i just want some insight before i spend the cash to get the new parts, now i know the 02 front is stock, but it sat a couple inches lower then my WW bumper did,

some food for thougt

the front bumper is about 4 " off the ground currently, so if you can build off that, thanks in advance

Prokit 1.4" drop and i barely clear my gutter for the road. I actually have to use board now that i have my 18"s and full exhaust done...



side shot...



There is quite a bit of clearance. I have around 5-6 inches from the bottom of bumper to the ground.

Joey go import fighter sides and rear with the ls front. I think that combo will make u happy. Type J in my opinion would be to wild looking for a stock front