I'm looking around, searching through the forums, and I havn't found the answer I needed. I should be lowering the car here in the next couple months, looking at the D-Spec and Tein combo at Gravana, and I wanna know what is too low for the BC2? That's the kit I'll get after it's lowered. Basically, it's the decision between the H-Tech's or the S-Tech's... Tein Sport High.Tech - Drop is 1.1" Front & 1.0" Rear and Tein Race S.Tech - Drop is 1.7" Front & 1.5" Rear (from Gravana's site)
Thanks!
well that rear is really low. if you go with the s-techs i bet you'll be draggin that rear every where
ya man.....trust me when i tell you, i have stock suspension on right now and its still low!!
afraid to see it on air
hmm... maybe I should get the kit first then do some measuring....
My buddy has the BC2 kit on his cavalier with sportlines and it sits an inch from the ground.. Hope that helps.
I have the Buddy Club 2 kit on my car & its lowered with Sprint Springs (1.8" front & back) & its fine except on "some" speed bumps the rear piece would slighty scrape but other than that just go slow when entering places
i have the bc2 kit and i'm on air and i dragged the rear to hell....
Sdwndr2 wrote:My buddy has the BC2 kit on his cavalier with sportlines and it sits an inch from the ground.. Hope that helps.
i dont know what ruler you are measuring with, i have a bc2 and sportlines, and it does not sit an inch from the ground. Its not too low. I live in pittsburgh, where there are tons of hills, and i have yet to do any damage to my kit after a year.
Are the sportlines a 1.7" Front to 2.3" Rear drop? That's what's on the gravana site... hmm
im lower than him on sportlines, its no big deal, really, just drive slow, and take the long way around.
yep. thats all it is.
I NEED a 97-99 LD9 engine harness for an auto.PM if u hav info.!!
