I have a 96 sunfire with a 2.2 and i changed the plugs, wires, coils, ignition moduel, and crank shaft position sensor and it still does not run i dont know what else too do with it
Is there spark?Are you getting any fuel?
01SilverFire wrote:Is there spark?Are you getting any fuel?
did you really ask him if he has spark ? oh man
first make sure you have the correct firing order. are you sure the plug wires are going to the right spark plugs ? second check your fuses. have someone try to jump your car. battery may be dead? or starter is out. and for the most obvious check for fuel.
Ok,What I want to say is are you getting spark on any cylinder?Some people might think that if you dont have spark on one cylinder that you not going to get spark on the others but that is not always the case.More trouble shooting info needed.
Just a guess. Having spark to plug when its out is something different than having spark to plug when it is in the combustion chamber under compression. So, if you have fuel in the rail, and you have spark to the plugs, the car should crank and fire up. If it isn't, dig deeper in to ignition circuit.
it has loads of fuel pressure it has no spark... period it has been like this now since the begining of august
Check the Timing chain or ECU is gone. My car just killed the ECU
Im having the same problem with my car... i changed all that stuff and still nothing, Ive been told to check the ground and make sure they are still connected on the block, batt, and to the frame. I just havent had time cause of finals. so i would check all of those
www.rdracing.110mb.com
