2.2 ecotech rolling over but not firing - Maintenance and Repair Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
2.2 ecotech rolling over but not firing
Tuesday, August 12, 2014 1:38 PM
My 2.2 ecotech 5spd. It had started getting harder to crank, then as I was letting out on the clutch it was hesitating like its fuel was cutting out! Went to moms got a shower came out to leave now it is turning over but not firing the fuel pump is kicking on and with the hood up cranking it pumping the fuel u can smell fuel! Still no fire!!

Re: 2.2 ecotech rolling over but not firing
Tuesday, August 12, 2014 3:55 PM
If you're getting fuel, check your spark.



Re: 2.2 ecotech rolling over but not firing
Monday, September 01, 2014 5:01 PM
Or check the EVAP purge solenoid.
Re: 2.2 ecotech rolling over but not firing
Monday, September 01, 2014 5:08 PM
Take off the solenoid and try to blow through it. If you can it's bad. Of you can't it's likely ok. But that can be the root of not firing sometimes. It's a fairly inexpensive part. Always a good start for something like that
Re: 2.2 ecotech rolling over but not firing
Sunday, July 26, 2015 11:38 AM
Does a 2005 Chevy Classic also have an evap purge solenoid? If so where is located?
Re: 2.2 ecotech rolling over but not firing
Sunday, July 26, 2015 4:40 PM
Check for spark by grounding the plug against the valve cover, without touching it while cranking, or a spark tester. If you have fuel check fuel pressure, key on engine off should read 41-47 psi, engine idling should be 31-44 psi.
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search