Hi All,

Anybody know where I can get either a used Stainless Steel header for a 2.2 OHV/non ecotec or just the flange? Even a damaged header from a wrecked car would be fine if the flange is OK.
I'm building a motor that will require a specific header dimension and so far I've found OBX with 4 to 2 to 1 configuration and Kamikaze with a 4 to 1. However, I need 1.75 inch primary tubes and 3" merge collector.
They both have smaller collectors

Thanks,

dennis

MasterFlight wrote:Hi All,

Anybody know where I can get either a used Stainless Steel header for a 2.2 OHV/non ecotec or just the flange? Even a damaged header from a wrecked car would be fine if the flange is OK.
I'm building a motor that will require a specific header dimension and so far I've found OBX with 4 to 2 to 1 configuration and Kamikaze with a 4 to 1. However, I need 1.75 inch primary tubes and 3" merge collector.
They both have smaller collectors

Thanks,

dennis

I think I saw some on JEGS, they're pretty good but they can be pretty pricey..

Thanks Jason,
Looks like they carry the gasket and 3 different headers, but no flange itself.
dennis

Try turbotechracing.com they are a supporting vendor and them may be able to help you out.

Ask and you shall receive....
http://www.carcustoms.net/product_info.php?cPath=265_22_32_598&products_id=434
The Link I posted is for the 98-02 2200 if you need pre 98' (earlier 2.2) that site also has them. Karo Is a great person to work with!
Good luck!

I make them, and have the instock.
I can also make desired runner sizes too.