I have a problem with the reflash and turbo kit
It's a cavy 2002 with a swap ecotec 2003 , a custom turbo kit and the management is the s/c reflash (Tmap and reflash) for ecotec.
the problem is that once the engine goes in to boost it will not take it and it goes very lean and then starts to buck.
The gaz management is a 36lbs Cobalt SS injector and FMU is aeromotive Ajustable fuel regulator. The boost is at 8pounds.
The engine compression is good and the gaz octane is 94. I don't know what the problem is anybody have an idea because i'ts my third motor that I install but my second motor had the same problem but the compression was no good.
Can you tell me how to wire the Tmap, I'm not sure that is okay.
Tmap emplacement? I put the Tmap at the same hole that the stock map sensor goes.
Bad reflash at the dealer but I put a friend computer with the s/c reflash and didn't run correctly eather.

thanks for the info.i just wanted to know if i did the wireing right.