The left side is almost done, I still have to finish off the right side.
I just thought I'd show this here before its finished.

I was going to get it powder coated black to match the rest of the engine bay, but I really like the reflective shine.

FYI the head is not sitting directly on the brick, there are 2 small rubber brick things holding it up.

<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -

Correct me if I'm wrong, but isn't that the valve cover and not the head?

Otherwise looks good.

yea thats not the head... valve cover buddy.. lookin good though

my mistake, I've been up for quite some time now...

<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -

But thanks for the compliments

<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -

You're going to have fun polishing that once a month lol.

looks like a decent start...

to get in around the smaller areas use a cue-tip in a dremel, works very good for tight spots. all you gotta do is cut one end of the cue-tip off and it fits (well, it fits in my dremel) perfectly.



Riddle me this... riddle me that...

Shadowfire wrote:You're going to have fun polishing that once a month lol.

Actually I have two valve covers, I got the one off of my old motor.
Its on the motor right now in the cavalier, I'm going to keep the polished head off of the motor till I know I'll be showing off the engine bay.

<img src="http://www.majhost.com/gallery/HCAJosh/crap/shooshined.jpg">
- putting the pieces back together -