I'll get mine probably this week with a hi flow cat, but I saw someone wrote in another post (I didn't wanted to be a thread jacker so I made a new one) that you have to extend the o2 sensor wire... Is it with the ecotec one or with any new pacesetter header?

I know that on the 95-97 2.2 you have to extend the wire. The O2 sensor is not in the header itself as in the factory one, it's below it in the pipe. I would assume that you have to extend it on all of them. Just get your solder gun out if you have to do it, it should take 5 min. Make sure to do it right because you want your O2 sensor to get a correct reading!

Jay




One huge aluminum wing - $200
More vinyl graphics than your ride can handle - $150
Decals for products you don’t even have - $10
500lbs of Car Audio equipment in the trunk - $1500
----------------------------------------------------------------------------
Getting slaughtered by a KIA - Priceless

I didnt have to extend the wire when I put the pacesetter header on my eco. I also reused the stock manifold gasket and havent had a leak for the 9 months its been on.

On a side note I will be selling my ceramic coated pacesetter header soon if you want to save some cash and by used.