I just got my bumper in and now I must sand prep and paint. But my quistion is this. It doesnt have any holes or such to attatch it to the car. SO how much I go about doing this!? Also how must I attatch the wire mess to the fx bumper securly?
JB Weld but it will never come out again
| '89 Z24 Auto | '99 Prelude 5spd | '04 GS500F | '05 HD 883L |
is that how you did yours? I see you have the same one...
drill your own holes.
test fit the kit, mark the holes, and drill.
Its only fiberglass. If you mess up you can just re-glass it
yeah but you have f/g fenders dont you?
RJ Miller wrote:yeah but you have f/g fenders dont you?
no, i have oem fenders. im sorry, i glassed my mesh in. the holes you just have to line up yourself. its prety simple.
-Www.IznTrbl.Com-
my mesh came in installed and its just held in by some lil stainless tabs that were glassed in with the bumper unfold and off comes the mesh as for the whole like others have said test fit and drill u can also have someone hold teh bumpers in and make a
mark with a marker from above the mounting points were the bolts hold in its how i did mine i worked good too
hope this helped a lil
00 cavi
http://www.cardomain.com/memberpage/795140
thanks you all I think I'ma use JB weld I gots a lot of that laying aroudn and I never thought of it...
