removing stock sideskirts??? - Exterior Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
removing stock sideskirts???
Monday, May 02, 2005 1:25 PM
someone told me that there is some bolts holding the stock skirts on inside the car and that i need to remove rear seat to remove them, my question is; is this true???

thnx in advance




Re: removing stock sideskirts???
Monday, May 02, 2005 1:30 PM
lmao, no. there's bolts along the under side of the car, and clips as well. remove the bolts, and i think there should be some screws on the ends, then pull the side skirts away from the car, getting the clips to release. not hard at all.




Re: removing stock sideskirts???
Monday, May 02, 2005 1:39 PM
thnx cannon for clearing that up for me....



Re: removing stock sideskirts???
Monday, May 02, 2005 5:22 PM
ha ha...........



Re: removing stock sideskirts???
Tuesday, May 03, 2005 4:19 PM
can i buy them from you?




Re: removing stock sideskirts???
Wednesday, May 04, 2005 7:25 AM
You mean those clips will pop out? I had to pry those bitches out with needle nose pliers.

Clay Daniel wrote:can i buy them from you?
I still have mine...



Re: removing stock sideskirts???
Wednesday, May 04, 2005 7:37 AM
They are one way "christmas trees" under the car and one screw on each end. I am putting gt skirts on my sunfire SE, i already swapped the front clip and back. You will have to ramove the back tires and just turn the fronts to get to the screw.




Re: removing stock sideskirts???
Wednesday, May 04, 2005 10:08 AM
JuggaloZeke wrote:You mean those clips will pop out? I had to pry those bitches out with needle nose pliers.


i just left my clips on the car... can't see em cause the type j sideskirts cover them up just fine.

[quote=ŠleveŽOnE]They are one way "christmas trees" under the car and one screw on each end. I am putting gt skirts on my sunfire SE, i already swapped the front clip and back. You will have to ramove the back tires and just turn the fronts to get to the screw.

shouldn't have to remove the back wheel, just gotta use a screwdriver that you can fit in there. i think i put a screw driver bit on my socket wrench and it fit just fine, worked easily to get the screw out and i didn't have to even touch the back wheel.




Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search