I've looked through the Hanes manual and of course "installation is the reverse" and I can't seem to find any useful information online - so I was wondering how do you go about realigning a new wiper motor onto the crack assembly. I plugged the motor in without the assembly, started thr wipers turned them off and wait for the motor to stop spinning - and I've been using that as a starting point, but I'm not sure how to align in, and to further complicate matters the crank assembly can like - detach itself and go around a more oval shaped track - which Im assuming has to do with the parking feature considering it would make the wipers go to an extreme on either end...but I just cant figure it out. Any help would be appreciated