Ok guys,
Here's the issue. I noticed my right rear turn signal went out today. I check the fuse first and that was clean and working. So I took out the turn signal and bulb. There was a lot of corrosion, but I cleaned most of that out as best I could with a wire brush. Put the new 3157 bulb in and..............nothing. The front turn signals are working fine on both sides as well as in hazard mode. Could this be my turn signal switch? Maybe try and clean it out with compressed air or wd-40? It's just weird that my front right signal works fine yet the back signal is not working. Any ideas would be awesome.

Thanks a ton!

ShiftyCav wrote:thats probably the dumbest thing i have ever heard. you should take that serpentine belt and wrap it around your neck.

I have the same problem, I'm probably going to replace the blub holder w/ one I cut out of a junkyard jbody

Any ideas why it would be just the right rear only? I really don't want to replace the bulb holder. Ohio weather is still fricking cold haha.

ShiftyCav wrote:thats probably the dumbest thing i have ever heard. you should take that serpentine belt and wrap it around your neck.

On my car it's a bad terminal I cleaned it with the spray stuff but the blub has to be in perfect for it to work I might just cut it out to fix it if of I'll wait till the next time it's warm and I'm off work to give it a better look