Hey ya'll.
I've got a 97 Z24, obviously with the 2.4. I recently had some major engine work done, as deep as a new crankshaft, and also boring .0030 for some larger pistons. The car FLYS and runs perfectly... My problem is, I don't think the computer is in sync with the engine work. I quite frequently get the following check engine codes:
- Camshaft Position Sensor
- Crankshaft Position Sensor
- Multiple Cylinder Misfire
- And something in regards to "Manufacturer Ignition Module" something or other (Going off memory at the moment)

Do you supposed this is just computer related, or do I really have a serious problem, and It's now apparent...

Is there anywhere I can go to correct the computer's malfunction, if that is the case?

Thanks ya'll, very much.

Dan