Hey folks.

'98 Sunfire GT

Just replaced my combination switch (turn signal, headlight, cruise) and all went smoothly, but when I put everything back together, I can't get the horn to work...

There are 2 leads for the horn connected to the back of the airbag, and they are soldered together in a spring.

Can anyone tell me where this is supposed to go so that the horn will work? I'm assuming it's to ground the leads? I really don't know...

any help would be great.

Thanks

Matt

'98 Sunfire GT
'04 Grand Am SE1 <br>

~-=:'98 GT:=-~

it gets it's 12v from the cig lighter fuse. not sure what your asking.

when you replaced the switch ..u pulled on the horn wire and it broke..or something..when i changed my headlight switch i was making damn sure to be careful on that wire,,my mechanice even told me to watch out for it

that spring goes into a hole in the column....when you install it you have to push down and turn it....when you turn it, it locks into place....if it doesnt want to lock then you prolly broke a little bit of plastic off the horn ring....if so then you have to replace the horn ring....it a cheap part, like 5 or so bucks <br>

Thank you.....i'll have to take off the airbag and take another look.....

<br>

~-=:'98 GT:=-~

Does anyone know what fuse the horn/cigarette lighter share? I couldn't find it listed on the panel on the side of the dash.