So I couldnt find out information on this so I went and made it my self.
This is a piece of billet aluminum machined to fit.
It has a 3/8" NPTF on the exit side and fits the stock o-ring.
If I get an interest of 5+ it would be around $50 ea.
Please PM me with any question, and lest get a list going.
This allows you to easily run an external Adjustable Fuel Pressure Regulator.
1.
2.
3.
4.
5.
That thread is very old and my prices are much lower!
Isn't that the same thing HAHN already sells for $20.99 (H TZ-5230)?
Not sure ..... didnt see it on their site?
Got a link?
Thats for the eco tec motor .....
Actually the regulators are the same on the ecotec since i have that part you have in the first pic on my ecotec.
Ricardo Rosario wrote:Actually the regulators are the same on the ecotec since i have that part you have in the first pic on my ecotec.
You sure it's the same port size, o-ring size, and thread size?
fortune cookie say: better a delay than a disaster
Well mine works for the 2.2 or 2200.
I cant speak for that one as I have no knowledge of it!
If anyone is interested please contact me.
I'm going to say yes since the regulator i had on my 2200 i put on my ecotec then now since i did all stainless lines i used that fitting he has in the first pic.But i could be wrong.
mad props on getting this done phil! what afpr are you going with? Also what are you going to do about the feed line? are you going to use the factory one or replace it with a stainless one?
Thanks Luis.
Im getting a custom stainless hose made at a local hydraulic shop, but still keeping the stock feed line fittings.
I have a knock off AFPR right now, but it works fine.
When I get the car complete I might change to an areomotive style.
