hey everyone i am looking for the correct sizes for the fuel line feed and return, as i am piping my fpr, the return is bigger, my guess is 5/16ths and not sure about the supply maybe 1/4 its a 95 2.2 motor. does anyone have a pinout of the icm module for my dis-2 box and interfaces, i found the one for the 2.4 but didn't know if they were the same.


thanks
jason

supply is the biggest and return is the smallest
supply is 5/16th
return is 3/8th



JBO since July 30, 2001

Well 5/16ths is smaller than 3/8ths so how do you figure?

How much fuel is really needing to return to the tank after much of it has been released from the rail via the injectors?


Go beyond the "bolt-on".