Grasshutperformance.com anyone try these from here before?
Ideas????
Jason
LZM Charges $80 for theirs..
And they support the various forums
blackbirdracing wrote:LZM Charges $80 for theirs..
And they support the various forums
Alot of people on here haven't had any luck at all with LZM.
its an old concept. time for something new to take the reigns. - Z yaaaa
hmmm that sucks,
I need to buy another set of balance shaft delete bushings...
what about DICE or ecofiero, he was making some wasnt he?
I ordered a set of the balance shaft bushings from LZM, and they were machined too big so they didnt fit in and they actually pushed the balance shaft bearings out of their place in the block. I had a set made that pressed into the bearing bore and they worked great.
Currently #4 in Ecotec Forced Induction horsepower ratings. 505.8 WHP 414WTQ!!!
Currently 3rd quickest Ecotec on the .org - 10.949 @ 131.50 MPH!!!
I have the LZM ones, they worked and went in great!
I know alot of people have had trouble with them in the past, but I ordered my BSD kit from then as well as my upper mount and never had a single issue.
DICE did make a kit, one of my friends just ordered it. His bushings are solid and have a threaded hole in the center so you can insert a threaded rod and remove them if you like, which is a very nice feature. Not sure if I would trust putting the balance shafts back in after you pounded in a bushing into the bearing....but I guess if the motor blows you can remove them and swap to a new block.
I have used LZM twice now with no problems...
I think i will just use them again.
