SRS FITMENT?????? - Performance Forum

Forum Post / Reply
You must log in before you can post or reply to messages.
SRS FITMENT??????
Saturday, March 12, 2011 1:57 PM
was able to pick up an SRS cat back system with a high flow magnaflow cat never used for cheap off a friend, it was meant for a 2000 cavalier 2 dr, will it fit my 02 sunfire 2 dr?? it is the 2.2 pushrod (before the ecotec). just wanna know before i go and rip the stock exhaust and cat off.
and the no welding thing for their exhaust is BS far as i can see

Re: SRS FITMENT??????
Saturday, March 12, 2011 2:31 PM
Should fit just fine. So is this SRS an eBay knock off of RS*R?


2010 Honda Fit LX
Re: SRS FITMENT??????
Saturday, March 12, 2011 4:12 PM
i am not sure but for an ebay knobkoff it looks really solid welds are all good and strong, muffler's welded on, and its all quality steel far as i can tellwith a nice polished look the full name is senkei revo sport if that helps
Re: SRS FITMENT??????
Saturday, March 12, 2011 4:44 PM
There are a couple of active threads on this already. They are a very nice exhaust. American made stainless and tig welds are very high quality.
Re: SRS FITMENT??????
Saturday, March 12, 2011 7:13 PM
i know sorry to start another this thread was just a check on fitment and unless someone believes or knows it wont fit my sunfire the moderators can close this thread
Re: SRS FITMENT??????
Saturday, March 12, 2011 7:26 PM
I keep hearing they are good build quality, good steel, but horrible fitment....

Fitment comes hand in hand with quality IMO. If it won't fit, then it sure isn't quality in my eyes....Seems to be like it is just another typical ebay exhaust...

Waiting for more info/pics...



Re: SRS FITMENT??????
Sunday, March 13, 2011 9:30 AM
I will snap some pics of mine once I do my fuel pump in a couple weeks. (Still a bit chilly out) mine cleared the axel alright but I had to make a new hangar for the muffler and the mid section came up short, but I just made my cat and downpipe to fit
Re: SRS FITMENT??????
Sunday, March 13, 2011 11:51 AM
so really the only problem is length so i should just pick up a bit more 2.5" piping amd weld that in where needed and be good to go?
Re: SRS FITMENT??????
Sunday, March 13, 2011 11:57 AM
If the only problems are length, then that's not too bad since most will be putting a mid stream resonator anyway..



Re: SRS FITMENT??????
Sunday, March 13, 2011 12:03 PM
well i will find out tomorow and let you know how it goes?? oh and i cant remember and cant/dont wanna jack the car up in this weather so it has an O2 bung/sensor i am going to have to put back in to the new cat or exhaust right?? sorry been a while since i was under it and dont have access to a shop until tomorow.
Forum Post / Reply
You must log in before you can post or reply to messages.

 

Start New Topic Advanced Search