This morning i started my car and found out my brake lights don't work. Is there a fuse or something i can check for because all 3 tail lights on my 94 2dr le sunbird out are. when i flip the switch for the lights, they work but when i press the brake, they brake lights don't work.
I did the fan switch mod last week, i don't think i cut through anywires, but are there wires around the pedals that are for the rear brake lights. my bro is driving me to work, hopefully its an easy fix i can do tonight. please help
2003 Cavalier 2dr. 5spd
check the fuse out first, there is one on the fuse panel check out your owners manual for its location, also it could be a brakeswitch its mounted on the brake pedal bracket
id check the brake light switch on the pedal. also try replacing a bulb, you may just have all 3 burnt out.
Well, I checked my brake light switch on the pedal, and its not getting a constant 12v source. So i guess i need to search for a open circuit or a bad ground somewhere. The fuse looks fine too. This is going to be a pita. You guys were right on the money tho, thanks for the heads up.
2003 Cavalier 2dr. 5spd
Well, i tested my hazard lights also, they dont work on the guage cluster or the exterier hazard lights. And my car makes a strange one or two clicking kind of sound when you turn the key to start position after the fuel pump finishes priming.
2003 Cavalier 2dr. 5spd
Well, i fixed my car guys. The fuse i checked before said Tail so i assumed it was for the brake lights. I noticed in my manual that the hazards/brake switch is on the same circuit and they use a s/lp fuse. So i swapped my courtesy fuse over to the s/lp side beacuse theyre rated the same and the brake lights work again. Everyone should be ok now as long as i don't have a bad short. Thanks for the suggestions guys, much appreciated. It would of sucked taking the bus to work today. lol
2003 Cavalier 2dr. 5spd
