Im looking for a set of just front brake lines...cheaper the better..phil
cheaper on quality or price?
obviously price but yes id liek cheaper in price ones that are of decent / good quality..i have the rear kit already with my rear discs but would like front ones..i see rk sprt has some....but havent seen any anywhere else..are there any better places to go..phil
Part numbers for just front kits? Hard to find just front kits (looking for Cavi and Park Ave front kits)
SPD RCR Z -
'02 Z24 420whp
SLO GOAT -
'04 GTO 305whp
W41 BOI -
'78 Buick Opel Isuzu W41 Swap
you can piece stuff together on summitracing.com. russell offers street legal lines (they have about a 1" rubber piece on each fitting) and earls and russell offers non-dot legal lines too. you should use 13-14" lines for the front. as for fittings, i BELIEVE that the front calipers are 10mm banjo fittings, and the hard line fitting is a M10x1 bubble flare (bubble only!). you can find it all on summit.
-----------------------------------------------------------------------
-----------------------------------------------------------------------
- Sold my beloved J in April 2010 -
Bringing this back from the dead... has anyone confirmed the info Viper posted or does anyone have part numbers? I just need fronts
dcampbellz24 wrote:Bringing this back from the dead... has anyone confirmed the info Viper posted or does anyone have part numbers? I just need fronts
Considering this post is 4 years old, I'd like to think that it's been figured out.
M62, 42's, ZZP 3", ZZP S3 H/E
214whp 190wtq
Next time I'll start a new thread instead of searching....
dcampbellz24 wrote:Next time I'll start a new thread instead of searching....
no please don't.
you'll just get referenced back saying "it's been posted, please search".
Edited 1 time(s). Last edited Tuesday, May 18, 2010 4:22 AM
my carDomain updated 3/2/10 Forged and Supercharged
haha yeah I was being sarcastic. I searched and only really found this thread from four years ago. I'm sure many have them on their cars so I wanted to add to the old thread instead of starting a new one. I've been on these boards for years I just don't post much as I usually search and find what I need to know. Anyways, I'm in the process of the NWF swap so I wanted the steel braided lines for that. I can find sets of stainless lines for the front and back on ebay for like $60 shipped but I hate buying things I don't need (rear stainless) since I'm going to be doing the IRS later this year. Just trying to be efficient with my money spending is all.
I bought everything to do mine separately .....
lol but we all know, my fronts arent stock
You will need the following for a stock set up ..... times 2 for both sides.
1x) 10 mm x 1.5 banjo bolt
2x) 10 mm crush washers
1x) 10 mm banjo x -3 an fitting
1x) -3 an x -3 an x 15 lg. stainless line
1x) -3 an x 3/16 chassis fitting
1x) chassis fitting clip
1x) 3/16 inverted flare nut
You will need to re-flare the sotck line from bubble to inverted flare.
This will fit into the new chassis fitting.
You should have no further questions after this.
