Ok so i have the 95-98 upper mounts for my car with the gravana coilovers... but im wondering how they all fit togeather? there is a black plastic ring that came with the mounts and im not sure how it goes on??
Also does that top metal cup part from the coilovers that holds the bearings fit into the top mount? it just doesnt seam right to have the mount sitting on the top of this cup as i can not even press it into place...
any pictures you guys have of the front please post them...
The First Twin Charged jbody
blue car (R.I.P) - 240whp @7psi..
silver car - 305whp 315lbs.tq @15psi (91 Octane) or 420whp & 425lbs.TQ @20psi (94 octane+Alcohol Injection)
All dynos run on a Mustang dyno
ok i think i found the answer to my own problem... but if you guys have actual pictures of your fronts please post them
The First Twin Charged jbody
blue car (R.I.P) - 240whp @7psi..
silver car - 305whp 315lbs.tq @15psi (91 Octane) or 420whp & 425lbs.TQ @20psi (94 octane+Alcohol Injection)
All dynos run on a Mustang dyno
well seperating was VERY easy for me but then i guess its cuz they are new and never been used... but i dont get this... what is this peice i have circled in red?? cuz if i put my mount togeather like shown in the diagram there is nothing to hold it from poping out the top ?? and the part that is cirlced i think is that holds it in and i do not have it... was this somthing that came with the gravana kit or the stock mounts??
The First Twin Charged jbody
blue car (R.I.P) - 240whp @7psi..
silver car - 305whp 315lbs.tq @15psi (91 Octane) or 420whp & 425lbs.TQ @20psi (94 octane+Alcohol Injection)
All dynos run on a Mustang dyno
