i am rebuilding my suspension with the tein ss and edfc

i just ordered new drive shafts ( driver and pass)
new tie rod ends inner (d and p)
new tie rod ends outter (d and p)
new ball joints (d and p)
and plan on ordering the prothane control arm bushings
and trans mounts

i already have installed
lower prothane motor mount
addco rear sway bar
vibrant front and rear strut tower braces

any other sugestions while im under there

george

Are your oem alxes F'd ?

I think you got it all covered.

yes they are f 'd

thats why i rebuilding everything
i just want to make sure i didnt miss any thing

i lowered the car on stock sturts and sleeve coilovers
i learned my lesson lol

george

If you haven't got a front sway bar, get one... and then Polyurethane D Link and End link bushings... that's all I can think of.

I did all the bushings on my old Z and My dad found it easier before you try and press the old bushings out, to take a drill to them and cut them up a bit so the rubber will tear out easier.

lol or you could do what we did the first time and take an Oxy/Ace torch and just burn them out.

sorry i do have the addco front sway bar waiting for the install

george

since your gonna have everything off how about wheel bearings? u might not need them but they are often over looked.

how much do wheel berings run?

george