So this weekend I am going to finally be installing my entire suspension setup! I got a lot of new goodies for my entirely overdue suspension.
I am installing new Monroe Strut Mounts, KYB AGX Shocks and Struts, Eibach Pro-Kit Springs, Moog Ball Joints, Control Arm bushings, Tie Rod Ends, and Steel Braided brake lines. My question is if there is anything I should know about any of the installs before i get myself too far into it. I know the bushings i would need a press for (I got one at work), a spring compressor for the springs, and i would also need need loc-tyte for the ball joints. Am i forgetting about anything else?
Got plenty of grease and an alignment down the street from me waiting.
Any tips would be greatly appreciated!
THANKS!
I'm back from the dead.
Currently Driving: RSX Type-S.
My Cavalier Burnt up :-(
Just updating, I didn't get a chance to get around to it this weekend. My family went up to VT, and i would have no ride for the weekend to get the nagging girlfriend.
Swear she owns me.
This weekend though, if weather prevails, it shall be done.
I'm back from the dead.
Currently Driving: RSX Type-S.
My Cavalier Burnt up :-(
