so i was at work yesterday and i decided i would go through a few boxes of wheel studs so i could find longer one and i found them 2006 hummer h3 wheel studs are a direct swap for stock studs but they are about 3/4 inch longer and that is exactly what i needed to run wheel spacers to make my slicks fit
Perfect! Junkyards are filled with them!
how pov are you to go to the junkyard to get wheel studs just buy them new since you have to hit them with a hammer to get them out
JBO since July 30, 2001
nice find mike, thanks for posting it up like i said.
unfortunately i already gave like $80 for a set of gmpp studs, oh well.
I feel like taking a tinkle on an ecNOtec...
I got some ARP corvette wheel studs that are a inch longer for $30 for 10 studs.. is that really that expensive? I mean i figure you can buy those hummer ones probably for a buck or two a piece at a parts store but the junkyard? really?
i paid a 1.68 a piece for them
Picks please....
PRND321 Till I DIE
Old Motor: 160whp & 152ft/lbs, 1/4 Mile 15.4 @88.2
M45 + LD9 + 4T40-E, GO GO GO
06 Hummer Front
Weight: 0.55 lbs
Application: Front
Type: Serrated stud
Thread Size:
M12-1.5
Hex Size:
12.80 mm.
Thread Length:
54 mm.
Seat Angle:
8 mm.
06 Hummer Rear
Weight: 0.05 lbs
Application: Rear
Type: Serrated stud
Thread Size:
M12-1.5
Hex Size:
12.73 mm.
Thread Length:
41.5 mm.
Seat Angle:
8 mm.
Jbody Front and Rear
Weight: 0.9 lbs
Application: With aluminum wheels
Type: Serrated stud
Thread Size:
M12-1.5
Hex Size:
12.73 mm.
Thread Length:
41.5 mm
Seat Angle:
8 mm
So as you can see.. the rears use the same length as the Jbodies but the fronts are 12.5mm longer
everything is the same except length it helps to work at a parts store thats how i found this
Yeah thanks ..... after I bought my 2.5" ARP studs
