okay so the outer drivers side sub frame mount bolt, the nut inside the frame has come apart and is no longer in place. I need to figure out how i can get a nut in there and my bolt back in so i can drive my car again...any ideas will be greatly appreciated.
1999 - Cavalier - 5speed - Exhaust - 17" rims - carbon fiber hood - the beater
all i can think of is cut a hole in the floor to access the sub-frame and then weld in a nut. any ideas?
1999 - Cavalier - 5speed - Exhaust - 17" rims - carbon fiber hood - the beater
Hole saw subframe (large enough to fit your hand in)
Pull out old bolt/nut
Replace with grade 8 nut, bolt, and washers. Add loc-tite for security.
-OR-
Clean up old busted bolt, and weld a new nut on to the stud. Then heat/lube/impact that bitch out.
Hopefully the second option works out for ya, good luck.
Jack Jenkins wrote:Hole saw subframe (large enough to fit your hand in)
Pull out old bolt/nut
Replace with grade 8 nut, bolt, and washers. Add loc-tite for security.
-OR-
Clean up old busted bolt, and weld a new nut on to the stud. Then heat/lube/impact that bitch out.
Hopefully the second option works out for ya, good luck.
yea its looking like im going to have to buy a bolt in case i can't find the bolt in the frame itself. Than weld that bastard on..
1999 - Cavalier - 5speed - Exhaust - 17" rims - carbon fiber hood - the beater
