I just installed a freedom design strut bar, on the front and the handleing is awesome. It was a huge improvment. Does anybody else have this strut bar, and if so have you had any problems with it at all, such as loose bolts or anythign of that nature? Anything that i might want to look out for. I installed it in an 03 cavi sedan with the cruise control, and i mounted the cruise control that is mounted to an engine mount on the top of the strut bar. It fit better that way. Thanks in advance.



<imgsrc="http://www.geocities.com/juicez99cav/cavy_sig_3.jpg">


I am what I am and it is what it is.
I am the 2nd most untrusted person in the world next to a lawyer,welcome to our dealership, may I help you?

i have these bars. no problems with loose bolts



Im a Xbox 360 fanboy...and damn proud of it!!

as long as it is installed properly then you should be just fine.




I was a retard, and now I'm permanently banned.

there should never be loose bolts...

simply make it tight...

i can honestly say out of every 100 braces i see, atleast 40 are just there and not tightened down..... worst mistake to make.

its like wearing underwear, but not pullin em up to cover your no no;s....its like if you are gonna install it or them, might as well do it right

Well, i have it installed and it is tight as tight can be, i even drove it around to make sure that everything is tight and when i went to check the bolts, the were tight as can be. I was just wondering in the long run if anything like that were to happen?

I also have a rear brace that i am gonna be installing, is it better to mount the brace on top of the bolts ar take them off and mount it.



<imgsrc="http://www.geocities.com/juicez99cav/cavy_sig_3.jpg">


I am what I am and it is what it is.
I am the 2nd most untrusted person in the world next to a lawyer,welcome to our dealership, may I help you?

well since there is only one nut to remove in the rear, basically its lay the plate over the one nut and 1 or 2 welded in nuts, and add 2-3 nuts depending on how many mounting points in the rear....

if bolts are tight up front, only way they will loosen is if done manually, realistically. so your fine.

I got front and rear and they both make a huge diff.

Now go buy the rear one and see what happens.





Semper Fi SAINT. May you rest in peace.

yup i got front and rear, aadco rear sway bar, b+g springs, and about to buy koni's, poly bushings. also want a subframe and gonna possibly do events rear tie bar mod. oh i also have phantom grip lsd and its lovely



Visit High Rev Motorsports for all your High Performance needs.

Visit RSM Racing for j-body superchargers, throttle bodies, and much more.

Visit Cobalt SS.Net and sign up to get the latest info on the cobalt and all other delta platform cars