Ok, now i know ur all going to saw in the door area place where u pull that trim piece up....RCA's on passenger side...power wire on drivers...but neways my question is...i have like...2 sets of RCAS going to the trunk, and speaker wires going up the passenger side (14 guage) and on the driver side theres speaker wires + a 2 guage power wire and there is NO ROOM to put the piece back in...like no matter where i position the wires it never works...is it possible to like rip the carpet up and run wires under there then under the back seat into the trunk? or is there some downside to that?? any help is appreciated

wysiwyg wrote:i would say they bang, they don't really pound so much. but if
you want to bump, then they will bump and hit real hard and a lot good.

LOL

You could do it that waym but you might get an annoying bump in the carpet.

I have (3) 4 gauge wires under the driver side trim in my fire, yes it was a pita to put the trim in, but there is room.


Your other option is to put it through the ceiling trim. Wires will be much longer but that too will work.

pull up the carpet, and put it near the corner. i have a lot of wiring under my carpet, and you cant tell.



-----------------------------------------------------------------------

-----------------------------------------------------------------------
- Sold my beloved J in April 2010 -

X2 i have a ton of wiring also. you cant see anything.

Thanks guys ill do that tomorrow

wysiwyg wrote:i would say they bang, they don't really pound so much. but if
you want to bump, then they will bump and hit real hard and a lot good.

LOL

same prob with 4 ga here, I just ran it under the carpet beside the plastic piece that holds all the wires, no bump, just a real pita.

i always pull a seat out and pull the carpet up. no sence in cramming them all into one spot when you have the entire floor to use.


http://www.flickr.com/photos/sndsgood/ https://www.facebook.com/#!/Square1Photography

thats wat im doing as we speak

wysiwyg wrote:i would say they bang, they don't really pound so much. but if
you want to bump, then they will bump and hit real hard and a lot good.

LOL

i also take a seat out when running multiple runs of wires like that. a lot easier to do.


--------------------------------------------------------------
Offical dealer for the following-

SOUNDSTREAM
DB LINK
DB DRIVE
PANASONIC
GARMIN
ROSEN
SCOSCHE
XE DESIGNS
SOUNDGATE
PAC
LITEGLOW

bah under car it

center console.... SOOO easy, bit of a bump in the rear seat floor but not noticeable at all.

I got em hid, just ran em under the carpet ... cant notice at all unless i got and push down and search for it thanks for the suggestions

wysiwyg wrote:i would say they bang, they don't really pound so much. but if
you want to bump, then they will bump and hit real hard and a lot good.

LOL

yea, pull up the center console and the back seat. i ran my rca's and my remote there. i drilled a hole in the change holder and put in a toggle switch for my remote to cut my amp off and on.