Ok here is the deal. I have a 1997 cavy 2 door and in the back on each side of the back seat the panels indent. I have three pairs of Lanzar DC44 Professional Series 4" speakers. I am looking to put one on each side and then mount a pair where the people in the back seats feet would go. Are these easy locations to put speakers and run wires to? Now these are not cheap speakers, they are some of Lanzars best line (if you didn't know). I hooked 4 of them up to a Rockford Fosgate 400.4 amp and they sound amazing. So please let me know how easy of an install this would be. Thank you in advanced!!!

I have a 3 way component set back there, but if you don't set it up right, your staging is going to sound like a cheetah getting slapped off of a dead chicken. I'd put all 3 sets in the back deck if you could, or all three in the side panels, angle them slightly forward, and stagger them. It's going to take a lot of trial and error on those since they are directional.

As for ease of running wires to and from this shouldnt be a problem if your planning on putting them where i think you are as you can just pull up the pieces of trim that sit on the ledge under the door when it is closed and run them through there like with wiring in a sub and amp, all you will have to then is feed them through to where your going to have the speakers, so that part should be nice and easy.



(99 - Sunfire - Red - 2200)(95 - Cavalier z24 - Purple - 2.3 quad four)