Hi, I am trying to install a 530T Window Automation System. It gives you the option to connect it to the aux spot for an alarm to vent the windows. Is there a way to get them to vent when unlocked instead of holding the aux. I have never installed one on a car with a factory alarm. All my cars have it with an aftermarket viper alarm.
http://www.directed.com/guides/manuals/ig/accessories/N530T_1-00.pdf
<img src="http://www.v6z24.com/jbodyforum/images/signatures/cavalier3400z.jpg" width="319" height="199"/>
Here are the 3 wires I need i need to run to the factory alarm. I cannot find a diagram showing these wires for the factory key less entry/ alarm. If anyone can help me out, it would be greatly appreciated.
H2/3 RED/WHITE (-) Auxiliary Input: Connect this wire to a (-) validity channel output of the security system.
H2/4 ORANGE (-) Ground-When-Armed: Connect this wire to the (-) ground-when-armed output of the
security system. This wire can also be connected to an auxiliary channel of the security system to roll the
windows up.
GRAY (-) OUTPUT DURING ACTIVATION
ORANGE (-) GROUND WHEN ARMED
RED/WHITE (-) AUXILIARY INPUT
H2/5 GRAY (-) Output During Activation: Connect this wire to an optional relay (P/N 610T) to bypass sensors
which may trigger the security system during operation. This wire continues to output negative (-) ground for 5
seconds after the window motors have
<img src="http://www.v6z24.com/jbodyforum/images/signatures/cavalier3400z.jpg" width="319" height="199"/>
Can anyone tell me which wire from the BCM keeps the radio on until the door is open? Also I am having issues wiring a relay to the door lock unlock and lock wires from the bcm to trigger my windows to roll up. Does anyone have a wiring diagram for the BCM?
<img src="http://www.v6z24.com/jbodyforum/images/signatures/cavalier3400z.jpg" width="319" height="199"/>
Anyone?
<img src="http://www.v6z24.com/jbodyforum/images/signatures/cavalier3400z.jpg" width="319" height="199"/>
I can't tell you much... but the BCM talks to the radio (and tells it to turn on and off) using a Class 2 signal... it's not a discrete input.
I figured it out. After market Radios stay on too when the car is turned off. I ended up wiring a relay to the key sensor. So when I remove the key from the ignition my windows roll up automatically. I haven't been able to wire the windows to vent when the car is unlock. I need to create a pulse since when you press unlock or lock it makes the windows go up or down an inch or two but after a few seconds they either go all the way down or all the way up. When I have time I will see if I can make it pulse but so far I am very happy with how everything is working.
<img src="http://www.v6z24.com/jbodyforum/images/signatures/cavalier3400z.jpg" width="319" height="199"/>
