Not being an ass, but have you searched?
It has been talked about a few times.
Look for Cobra Heat exchanger
About any set up that is proven on another car is fine for this set up I think...more of a personal preference.
I have the aftermarket Lightning HE and a ZZPerformance pump on mine and it seems to do the job...cost is another issue so look around and see what the prices are as you may find things a bit cheaper by checking prices for a week or so.
Eh...old man with a Corvette now...it was bound to happen sooner rather than later right?
lots and lots of 90 degree elbows and 3/4 inch heater hose....oh yeah...lots and lots of clamps and hose connectors!
hahaha!
I would like to redo it all to give it a cleaner look but I guess it works fine like this...just hate how it looks from under the car!
Eh...old man with a Corvette now...it was bound to happen sooner rather than later right?
I'm not sure you could use piping...I mean I guess if you had it all custom made and stuff but you aren't moving air......you are moving coolant so I think heater hose would work better?
Again...as I always say though I'm not the smartest guy around here by any stretch of the imagination so I'll let someone else chime in on that one...
But, I used heater hose as that was what everyone else went with and I think you'd have a hard time getting piping to connect up and with the limited space and the manifold, HE, pump, etc...IDK...just can't see it working and being cost effective?
Eh...old man with a Corvette now...it was bound to happen sooner rather than later right?
