hi there i am having lots of trouble running my charger pipes on the car right now i have 2.5". its ran underneath the car, i have the car lowered and i can barely go down the road without it scraping everytime a hit a little bump. @!#$y roads in this little town. so iam woundering if there are any disadvantages of switching from a 2.5 to a 2" for my charger pipes. what do you think? any info is greatly appreciated.

take a pic and post how they're routed right now.


-Trailblazer SS - not so custom 6.0L - custom intake - custom tune
- (1) 2.4L on an engine stand (1) blown trans (2) good quad trans (1) eco trans = party

sorry man i lost my digital camera. there are routed under the car and they go snug between the down pipe for the thermostat and then up to my intercooler. near the front there is very litle room. like i said every bump and they scrape the ground

Did you just buy a universal kit off of ebay? I purchased u bends and mine fits the curve under the engine and goes by the lower motor mount and and it sits a little bit higher up than the bottom of my oil pan. I actually found a picture of somebody setup from the org. they had on cardomain and kinda went from there.


~Boost. Its what's for dinner!~