I was curious, is there a How-to anywhere for installing the 03-04 cobra HE in a SC eco? What controls the pump? Where/how do you mount it? What parts do I need?

Yes I did search, Could not find a how to


Thanks

For the electrical controls for the fuel pump you will need a 4 wire relay. Connect the control circuit to the fuel pump relay power circuit and the other side to ground. Then on the power side get B+ and the other wire to the pump. Then the other wire on the water pump to ground.

I have my water pump attached to the block with the cobalt water pump bracket and I bought the water pump insulator also.
I bought bwoody intercooler brackets to hold the intercooler in place and ran heater hose to my mustang cobra resevoir. You need two 90 deg. hoses off of the intake manifold (it's a tight fit)

this is the post that i used as a guide when i installed mine. look at the pics halfway down on page 2. i routed my lines the same way phlatcav did

clicky

BLWN L61 wrote:this is the post that i used as a guide when i installed mine. look at the pics halfway down on page 2. i routed my lines the same way phlatcav did

clicky

Same thing I used...




Eh...old man with a Corvette now...it was bound to happen sooner rather than later right?

SOUNDS GOOD I AM GETTING MINE SHORTLEY

JUST CURIOUS AS TO WHAT YALL TIED THE WIRE INTO FOR THE PUMP?